Installation guide

Chapter 2 45

Installing the IO Libraries

Maintaining Existing IO Libraries

This section gives guidelines to modify, repair, or remove the same version

of the IO Libraries (version J.01.00 or later) currently installed on your PC.

n To modify the same version of an existing IO Library, see

“Steps to Modify IO Libraries”.

n To repair the same version of an existing IO Library, see

“Steps to Repair IO Libraries”.

n To remove the same version of an existing IO Library, see

“Steps to Remove IO Libraries”.

Steps to Modify the IO Libraries

1 Turn the PC ON and close all open applications.

2 Insert the Agilent IO Libraries for Instrument Control CD into the

CD-ROM drive and wait a few seconds for the application to run.

The installer should automatically start when the CD is inserted.

If not, select Start|Run

and type <drive>:setup.exe where

drive is your CD-ROM drive letter.

3 The InstallShield

Wizard appears to begin the IO Libraries

modification process.