Installation guide

36 Chapter 2
Installing the IO Libraries
Upgrading Existing IO Libraries
Upgrading Existing IO Libraries
Use these steps to upgrade existing IO Libraries on your PC. The steps in
this section assume version H.01.03 or earlier of the IO Libraries is already
installed on your PC and you are installing version J.01.00 or later of the IO
Libraries.
n If no version of the IO Libraries is installed on your PC and you
want to install a
new version, see “Installing New IO Libraries”.
n If you want to modify, repair, or remove the same version of an
existing IO Library, see “Maintaining IO Libraries”.
Steps to Upgrade the IO Libraries
1 Turn the PC ON and close all open applications.
2 As required, install application software such as C/C++, VEE, etc.
on your PC.
3 Insert the Agilent IO Libraries for Instrument Control CD into the
CD-ROM drive and wait a few seconds for the application to run.
The installer should automatically start when the CD is inserted.
If not, select Start|Run
and type <drive>:setup.exe where
drive is your CD-ROM drive letter.
4 The InstallShield
Ò
Wizard appears to begin the IO Libraries
installation.