Installation guide

Chapter 2 31
Installing the IO Libraries
Installing New IO Libraries
9 Move through the screens (as applicable to the option selected)
until you get to the
IO Libraries Configuration screen. Then, select
the type of configuration you want performed (automatic, manual,
or none) and click Next > to start the installation.
10 When installation is complete, the
Installation Complete screen
appears. Note that you must re-start your computer to initialize the
IO Libraries. Select the Do not configure interfaces now
option, remove any disks from their drives, and click Finish to
complete the installation.
11 Shut down the computer and turn power off. Install an IEEE-1394
FireWire card and/or Agilent 82350A PCI GPIB card. Use a
FireWire cable to connect the IEEE-1394 card to an E8491B VXI
interface card in a VXI mainframe. Power up the mainframe.
12 Turn the computer ON. As Windows 95/98/Me/2000 restarts, the
Found New Hardware Wizard will start. Use this Wizard to complete
the installation as shown in Steps 14 and/or 15.