Installation guide

Chapter 2 27
Installing the IO Libraries
Installing New IO Libraries
Steps to Install New IO Libraries (Modified)
1 Turn the PC ON and close all open applications. As required,
install application software such as C/C++, VEE, etc. on your PC.
2 Insert the Agilent IO Libraries for Instrument Control CD into the
CD-ROM drive and wait a few seconds for the application to run.
The installer should automatically start when the CD is inserted.
If not, select Start|Run and type <drive>:setup.exe where
drive is your CD-ROM drive letter.
3 The InstallShield
Ò
Wizard appears to begin the IO Libraries
installation.
NOTE
This section applies
ONLY to the systems listed. For a Windows NT 4.0
operating system OR for other IO cards, do
NOT use this section. Use
“Steps to Install New IO Libraries (Standard)”.
n Windows 95/98/Me/2000 operating system and a 1394 PCI
FireWire card connected to an Agilent E8491B VXI interface
or
n Windows 95/98/Me/2000 operating system and an Agilent 82350
PCI GPIB card.