Installation guide

108 Chapter 4
Configuring I/O Interfaces
Configuring Other Interfaces
When the E2075 ISA GPIO Card Configuration screen appears, set the
attributes as desired. Then, click the
OK button.
Example:
Configuring GPIO
Interfaces
The GPIO interface system in the following figure consists of a Windows PC
with an E2075A GPIO card that is connected to a GPIO instrument via GPIO
cable.
The IO Config utility has been used to assign the E2075A GPIO card a
SICL name of “gpio12”. (GPIO is NOT supported by VISA.) Since unique
names have been assigned by IO Config, you can now use the SICL iopen
command to open the I/O paths to the GPIB instruments as shown in the
figure. See the Agilent SICL User’s Guide for Windows for details on SICL
commands.