User`s manual

82 Index
L
linking commands, 39
logical address switch, setting, 16
M
Manufacturer ID register, 72
matrixes,creating larger, 23
O
OUTPut subsystem
OUTPut:ECLTrg[:STATe], 45
OUTPut:ECLTrg[:STATe]?, 46
OUTPut[:EXTernal][:STATe], 46
OUTPut[:EXTernal][:STATe]?, 47
OUTPut:TTLTrg[:STATe], 48
OUTPut:TTLTrg[:STATe]?, 49
P
power-on/reset conditions, 32
programming
addressing switches, 28
register-based, 69
using SCPI, 28
Q
querying switches, 32
R
recalling/saving states, 34
register-based programming, 69
registers
addressing, 69
base address, 70
Device Identification, 73
Manufacturer ID, 72
Relay Control, 74
Status/Control, 73
relay control registers, 74
relay life, 79
relay matrix switches
addressing, 28
checking module identification, 33
commands, 31
configuring, 15
connector pinouts, 11
description, 11
detecting error conditions, 35
error messages, 77
initial operation, 29
installing, 18
power-on/reset conditions, 32
programming, 28
querying, 32
specifications, 67
switching channels, 33
synchronizing, 36
relays
end-of-life determination, 79
life factors, 79
replacement strategy, 79
restricted rights statement, 7
[ROUTe:] subsystem
[ROUTe:]CLOSe, 50
[ROUTe:]CLOSe?, 51
[ROUTe:]OPEN, 52
[ROUTe:]OPEN?, 53
[ROUTe:]SCAN, 53
S
safety symbols, 8
SCPI commands
command reference, 39
quick reference, 66
SCPI, using, 28
setting logical address switch, 16
specifications, 67
Status register switch, setting, 16
status/control register, 73
STATus subsystem
STATus:OPERation:CONDition?, 56
STATus:OPERation:ENABle, 57
STATus:OPERation:ENABle?, 57
STATus:OPERation[:EVENt]?, 58
STATus:PRESet, 58
switch descriptions, 11
switching channels, 33
synchronizing switches, 36
SYSTem subsystem
SYSTem:CDEScription?, 59
SYSTem:CPON, 59
SYSTem:CTYPe?, 60
SYSTem:ERRor?, 60
T
terminal modules
attaching to relay switch module, 27
configuring/wiring, 20
TRIGger subsystem
TRIGger:SOURce, 63
TRIGger:SOURce?, 64
TRIGger[:IMMediate], 62
W
WARNINGS, 8, 15
warranty statement, 7