User`s manual

Relay Matrix Switch Command Reference 57Chapter 3
STATus:OPERation:ENABle
STATus:OPERation:ENABle <unmask> sets an enable mask to allow
events recorded in the Event Register to send a summary bit to the
Status Byte Register (bit 7). For Relay Matrix Switch modules, when bit
8 in the Operation Status Register is set to 1 and is enabled by the
STAT:OPER:ENABle command, bit 7 in the Status Register is set to 1.
Parameters
Comments Setting Bit 7 of the Status Byte Register: STATus:OPERation:ENABle 256
sets bit 7 of the Status Byte Register to 1 after bit 8 of the Operation
Status Register is set to 1.
Related Commands: [ROUTe:]SCAN
Example Enabling Operation Status Register Bit 8
STAT:OPER:ENAB 256
!Enables bit 8 of the Operation
!Status Enable Register to be
!reported to bit 7 (OPR) in the
!Status Register.
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns the bit value of the Operation Status
Register.
Comments Output Format: Returns a decimal weighted value from 0 to 65,535
indicating which bits are set to true.
Maximum Value Returned: The value returned is the value set by the
STAT:OPER:ENAB <unmask> command. However, the maximum
decimal weighted value used in this module is 256 (bit 8 set to true).
Example Query the Operation Status Enable Register
STAT:OPER:ENAB?
!Queries the Operation Status
!Enable Register
Name Type Range of Values Default Value
<unmask> numeric 0 through 65,535 N/A