User`s manual

5. Set the Frequency
[SOURce:]FREQuency[1][:FIXed] <frequency>
This command specifies the frequency. Refer to Table B-3 in
Appendix B for the frequency limits.
6. Select the Function
[SOURce:]FUNCtion[:SHAPe] SQUare
This command selects the square wave function.
7. Select the Square Wave Polarity
[SOURce:]RAMP:POLarity INVerted
This command selects the square wave polarity. For NORMal, the
initial voltage goes positive. For
INVerted, the initial voltage goes
negative.
8. Set the Amplitude
[SOURce:]VOLTage[:LEVel][IMMediate][:AMPLitude] <amplitude>
This command specifies the amplitude. Refer to the section called
“Selecting the Amplitude Levels and Output Units” on page 72 for
more information.
9. Set the Offset
[SOURce:]VOLTage[:LEVel][IMMediate]OFFSet <offset>
This command specifies the offset. Refer to the section called
“Selecting the Amplitude Levels and Output Units” on page 72 for
more information.
10. Initiate the Waveform
INITiate[:IMMediate]
This command generates an immediate output with the arm source set
to
IMMediate. Refer to Chapter 5 for triggering information.
62 Generating Standard Waveforms Chapter 2