User`s manual

Standard Waveforms Flowchart
The flowchart in Figure 2-1 shows the sequence used to generate standard
waveforms. The reset (power-on) values of each command are also noted
on the flowchart. The programs in this chapter begins with a reset (the
IEEE 488.2
*RST command) which places the AFG into its power-on state.
Thus, the programs do not execute all of the commands on the flowchart.
Remove the flowchart from the binder for easy accessibility. Refer to the
flowchart while doing the examples in this chapter, if desired.
Figure 2-1. Commands for Generating Standard Waveforms
(continued on next page)
54 Generating Standard Waveforms Chapter 2