User`s manual

Common Commands Quick Reference
This section describes the IEEE-488.2 Common Commands implemented in the
Agilent E1445A. The table below shows the commands listed by functional group;
however, commands are listed alphabetically in the reference. Examples are shown
in the reference when the command has parameters or returns a non-trivial response;
otherwise, the command string is as shown in the table. For additional information,
refer to IEEE Standard 488.2-1987.
Table 8-4. Agilent E1445A Common Commands
Category Command Title
System Data *IDN?
*PUD <
data>
*PUD?
Identification Query
Protected User Data Command
Protected User Data Query
Internal Operations *LRN?
*RST
*TST?
Learn Device Setup Query
Reset Command
Self Test Query
Synchronization *OPC
*OPC?
*WAI
Operation Complete Command
Operation Complete Command
Wait-to-Continue Command
Macro *DMC <
name>,<data>
*EMC <
enable>
*EMC?
*GMC? <
name>
*LMC?
*PMC
*RMC <
name>
Define Macro Command
Enable Macro Command
Enable Macro Query
Get Macro Contents Query
Learn Macro Query
Purge Macros Command
Remove Individual Macro Command
Status and Event *CLS
*ESE <
mask>
*ESE?
*ESR?
*SRE
*SRE?
*STB?
Clear Status Command
Standard Event Status Enable Command
Standard Event Status Enable Query
Standard Event Status Register Query
Service Request Enable Command
Service Request Enable Query
Read Status Byte Query
Trigger *TRG Trigger Command
Stored Settings *RCL
*SAV
Recall Command
Save Command
428 Command Reference Chapter 8