User`s manual

*RST
*RST resets the Agilent E1445A as follows:
– Sets all commands to their *RST state.
– Aborts all pending operations including waveform generation.
*RST does not affect:
– The state of VXIbus word serial protocol
– The output queue
– The Service Request Enable Register
– The Standard Event Status Enable Register
– The enable masks for the Operation Status and Questionable Signal Registers
– Calibration data
– Calibration security state
– Protected user data
– The DAC code format (signed vs. unsigned)
– Waveform segment, segment sequence, and frequency list definitions
Comments • Executable when Initiated: Yes
• Coupling Group: None
• *RST Condition: None
*SAV
*SAV <number> stores the current programming state into one of the 10 possible stored
state areas. The
<number> indicates which of the stored state areas should be used.
This command stores the states of all commands affected by
*RST. Notable exceptions
include the DAC code format (signed vs. unsigned), the
[SOURce:]LIST commands,
including waveform segment, segment sequence, and frequency list definitions, the
STATus subsystem commands, and the CALibration:SECure command state.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
number>
numeric 0 through 9 none
Comments • Executable when Initiated: Yes
• Coupling Group: None
424 Command Reference Chapter 8