User`s manual

*OPC?
*OPC? causes the Agilent E1445A to wait for all pending operations to complete.
A single ASCII “1” is then placed in the output queue.
If
STATus:OPC:INITiate OFF is set, the ASCII “1” will be placed in the output
queue when all commands received prior to the
*OPC? have been executed. If ON
is set, *OPC? waits for waveform generation to complete before placing the “ 1” in
the output queue. No other commands will be executed until the “1” is placed in
the output queue.
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: *OPC, *WAI
•
*RST Condition: None
*PMC
*PMC purges all macro definitions.
Comments • Use the *RMC command to purge an single macro definition.
• Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: *DMC, *RMC
•
*RST Condition: None
Chapter 8 Command Reference 421