User`s manual

:OPERation:CONDition?
STATus:OPERation:CONDition? returns the contents of the Operation Condition
Register. Reading the register does not affect its contents.
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: STATus commands, *SRE, *STB?
•
*RST Condition: All bits of the Operation Condition Register are cleared as a
result of the state present after
*RST.
Example Querying the Operation Condition Register
STAT:OPER:COND? Queries the Operation Condition Register.
:OPERation:ENABle
STATus:OPERation:ENABle <unmask> specifies which bits of the Operation
Event Register are included in its Summary bit. The Summary bit is the bit-for-bit
logical AND of the Event Register and the unmasked bit(s).
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
unmask>
numeric or
non-decimal
numeric
0 through +32767 none
The non-decimal numeric forms are the #H, #Q, or #B formats specified by
IEEE-488.2.
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: STATus commands, *SRE, *STB?
•
*RST Condition: Unaffected
• Power-on Condition: STATus:OPERation:ENABle 0
Example Setting the Operation Register Enable Mask
STAT:OPER:ENAB #H0040 Enables summary on Waiting for Arm bit.
STATus
Chapter 8 Command Reference 383