User`s manual

[:LEVel][:IMMediate][:AMPLitude]:UNIT[:VOLTage]
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]:UNIT[:VOLTage] <units>
sets the default units for subsequent
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] commands.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
units> discrete DBM | DBMW | V | VPK | VPP |
VRMS | W
none
Comments • The available default units are:
– DBM | DBMW: dB referenced to 1 milliwatt.
– V: Volts. This is equivalent to VPK for time-varying waveforms.
– VPK: Volts peak
– VPP: Volts peak-to-peak
– VRMS: Volts RMS
– W: Watts
For W, DBM, and DBMW, the amplitude is referenced to the
OUTPut[1]:LOAD
value; they are meaningless and therefore unavailable if OUTPut[1]:LOAD INFinity
is set.
• Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: OUTPut[1]:IMPedance, OUTPut[1]:LOAD,
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
•
*RST Condition:
SOURce:VOLTage:LEVel:IMMediate:AMPLitude:UNIT:VOLTage V
Example Setting the Default Voltage Units
VOLT:UNIT:VOLT VPP Sets default units to volts peak-to-peak.
[SOURce:]VOLTage
Chapter 8 Command Reference 379