User`s manual

:SPACing
[SOURce:]SWEep:SPACing <mode> selects either linear or logarithmic
frequency sweep mode.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
mode> discrete LINear | LOGarithmic none
Comments • The available modes are:
– LINear: Selects the linear sweep mode. The sample rate or waveform frequency
increases or decreases linearly between the start and stop frequencies selected by
[SOURce:]FREQuency[1]:STARt and STOP, or CENTer and SPAN.
– LOGarithmic: Selects the logarithmic sweep mode. The sample rate or
waveform frequency increases or decreases logarithmically between the start and
stop frequencies selected by
[SOURce:]FREQuency[1]:STARt and STOP, or
CENTer and SPAN.
• Executable when Initiated: Query form only
• Coupling Group: Frequency
• Related Commands: [SOURce:]FREQuency[1]:CENTer, MODE, SPAN, START,
and
STOP, [SOURce:]SWEep:DIRection and POINts
•
*RST Condition: SOURce:SWEep:SPACing LINear
Example Setting the Frequency Sweep Spacing
SWE:SPAC LOG Selects logarithmic spacing.
[SOURce:]SWEep
Chapter 8 Command Reference 375