User`s manual

• *RST Condition: SOURce:SWEep:COUNt 1
Example Setting the Sweep Count
SWE:COUN 10 Sets 10 sweeps per INITiate.
:DIRection
[SOURce:]SWEep:DIRection <direction> selects the direction of the frequency
sweep.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
direction>
discrete DOWN | UP none
Comments • The available directions are:
– DOWN: The sweep starts at the stop frequency specified by
[SOURce:]FREQuency[1]:STARt and STOP, or CENTer and SPAN and ends at
the start frequency.
– UP: The sweep starts at the start frequency specified by
[SOURce:]FREQuency[1]:STARt and STOP, or CENTer and SPAN and ends at
the stop frequency.
• Executable when Initiated: Query form only
• Coupling Group: Frequency
• Related Commands: [SOURce:]FREQuency[1]:CENTer, MODE, SPAN, START,
and
STOP, [SOURce:]SWEep:POINts and SPACing
•
*RST Condition: SOURce:SWEep:DIRection UP
Example Setting the Sweep Direction
SWE:DIR DOWN Sweeps down in frequency.
[SOURce:]SWEep
Chapter 8 Command Reference 373