User`s manual

Example Setting the “Marker Out” BNC Source
MARK:FEED “SOUR:LIST” Sets marker list as source.
:POLarity
[SOURce:]MARKer:POLarity <polarity> selects the polarity of the marker signal
at the front panel “Marker Out” BNC.
NORMal polarity selects an active high
marker output;
INVerted an active low output.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
polarity> discrete INVerted | NORMal none
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: [SOURce:]MARKer:FEED, [SOURce:]MARKer[:STATe]
•
*RST Condition: SOURce:MARKer:POLarity NORMal
Example Setting the “Marker Out” BNC Polarity
MARK:POL INV Sets active low output.
[:STATe]
[SOURce:]MARKer[:STATe] <mode> enables or disables the routing of the
currently selected marker signal (
[SOURce:]MARKer:FEED command) to the front
panel “Marker Out” BNC.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
mode> boolean OFF | 0 | ON | 1 none
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: [SOURce:]MARKer:FEED, [SOURce:]MARKer:POLarity
•
*RST Condition: SOURce:MARKer:STATe ON
Example Enabling Marker Output to “Marker Out” BNC
MARK ON Enables “Marker Out” BNC.
[SOURce:]MARKer
364 Command Reference Chapter 8