User`s manual

[:SEGMent]:VOLTage
[SOURce:]LIST[1][:SEGMent]:VOLTage <voltage_list> defines the series of
output voltage points that constitute a waveform segment. The points are specified
in terms of volts.
Parameters The <voltage_list> may be either a comma-separated list of voltage values or an
IEEE-488.2 definite or indefinite length block containing the values in IEEE-754
64-bit floating-point format.
The legal range for voltage values is specified by the
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] command. Default units are
volts.
MINimum and MAXimum cannot be used with this command.
Comments • If block format is used, the most significant byte of each value must be sent first.
• The voltage point list length must be at least four points long but no longer than
the reserved length specified by
[SOURce:]LIST[1][:SEGMent]:DEFine. If the
voltage point list length is less than the reserved length, only the number of points
specified by the most recent voltage point and marker pulse list is generated when
the waveform segment is output.
• The waveform segment’s marker pulse list length must be the same length as its
voltage point list, or must have a length of 1. If not, executing the
INITiate:IMMediate
command generates Error +1104,"Segment lists of different lengths".
• Changing marker pulse values preserves the waveform segment’s voltage point
list, and vice versa.
• The voltage values specified by this command are scaled relative to the full-scale
output voltage specified by
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
in effect at the time the voltage point list is created. Subsequently changing the
full-scale output voltage will change the actual output voltages that are generated,
and also the values returned by the query form of this command.
• Executable when Initiated: No
• Coupling Group: None
• Related Commands: [SOURce:]LIST[1][:SEGMent]:COMBined,
[SOURce:]LIST[1][:SEGMent]:VOLTage:DAC,
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
•
*RST Condition: Unaffected
• Power-On Condition: No waveform segments are defined
[SOURce:]LIST[1]
Chapter 8 Command Reference 345