User`s manual

• *RST Condition: Unaffected
• Power-On Condition: No waveform segments are defined
Example Creating a Single Point Marker List
LIST:SEL ABC Selects waveform segment ABC.
LIST:DEF 8 ABC is 8 points long.
LIST:VOLT -1,.5,.5.,5.,.5,0,-.5,-1 Defines waveform voltages.
LIST:MARK:SPO 5 Outputs a marker pulse on the fifth voltage
point.
[:SEGMent]:SELect
[SOURce:]LIST[1][:SEGMent]:SELect <name> selects a waveform segment for
subsequent
[SOURce:]LIST[1][:SEGMent] subsystem commands. This command
will define the waveform segment name if it is undefined, but does not reserve any
waveform segment memory.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
name>
character data 1 through 12 characters | NONE none
NONE selects no waveform segment
Comments • Legal names must start with an alphabetic character and contain only alphabetic,
numeric, and underscore ("_") characters. Alphabetic character case (upper
versus lower) is ignored. No waveform segment may have the same name as any
segment sequence.
• A maximum of 256 waveform segment names may be defined at any time. Use
the
[SOURce:]LIST[1][:SEGMent]:DELete:ALL or SELected commands to delete
names that are no longer needed.
• Executable when Initiated: Yes
• Coupling Group: None
• *RST Condition: Unaffected
Example Selecting a Waveform Segment
LIST:SEL ABC Selects waveform segment ABC.
[SOURce:]LIST[1]
344 Command Reference Chapter 8