User`s manual

:MODE
[SOURce:]FREQuency[1]:MODE <mode> determines which set of commands
control the frequency subsystem.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
mode> discrete CW | FIXed | FSKey | LIST |
SWEep
none
Comments • The <mode> parameter has the following meanings:
– CW or FIXed: Selects single-frequency mode. [SOURce:]FREQuency[1][:CW |
:FIXed]
selects the sample rate or waveform frequency. CW and FIXed are
equivalent.
– FSKey: Selects frequency shift keying mode. [SOURce:]FREQuency[1]:FSKey
and the front panel’s “Stop Trig/FSK/Gate In” BNC select the two sample rate
or waveform frequencies.
– LIST: Selects frequency list mode. [SOURce:]LIST2:FREQuency sets the
sample rate or waveform frequencies.
– SWEep: Selects frequency sweep mode. [SOURce:]FREQuency[1]:CENTer,
SPAN, STARt and STOP commands set the sample or waveform frequency
range. The
[SOURce:]SWEep, ARM:SWEep, and TRIGger:SWEep subsystems
control the sweep.
• Executable when Initiated: Query form only
• Coupling Group: Frequency
• Related Commands: TRIGger[:STARt]:SOURce, [SOURce:]FREQuency[1]
subsystem, [SOURce:]LIST2 subsystem, [SOURce:]SWEep subsystem
• *RST Condition: SOURce:FREQuency1:MODE FIXed
Example Setting the Frequency Sweep Mode
FREQ:MODE LIST Sets the frequency sweep mode.
[SOURce:]FREQuency[1]
Chapter 8 Command Reference 325