User`s manual

:FILTer[:LPASs][:STATe]
OUTPut[1]:FILTer[:LPASs][:STATe] <mode> enables or disables the output filter.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
mode> boolean OFF | 0 | ON | 1 none
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: OUTPut[1]:FILTer[:LPASs]:FREQuency
•
*RST Condition: OUTPut1:FILTer:LPASs:STATe OFF
Example Enabling the 10 MHz Low-pass Filter
OUTP:FILT:FREQ 10 MHZ Selects 10 MHz output filter.
OUTP:FILT ON Enables output filtering.
:IMPedance
OUTPut[1]:IMPedance <impedance> sets the Agilent E1445A’s output
impedance to either 50Ω or 75Ω.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
impedance> numeric 50 | 75 | MINimum | MAXimum Ohms
MINimum selects 50Ω output impedance; MAXimum selects 75Ω.
Comments • Executable when Initiated: Yes
• Coupling Group: Voltage
• Related Commands: OUTPut[1]:LOAD, OUTPut[1]:LOAD:AUTO
•
*RST Condition: OUTPut1:IMPedance 50
Example Setting 75 Ω Output Impedance
OUTP:IMP 75 Sets 75 Ω output impedance.
OUTPut[1]
Chapter 8 Command Reference 309