User`s manual

:STATe:DC
CALibration:STATe:DC <state> specifies whether DC corrections using the
calibration constants are made or not. If state is
OFF, then no DC corrections are
made. If state is
ON, DC corrections will be made if CALibration:STATe ON is also
set.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
state> boolean OFF | 0 | ON | 1 none
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: CALibration:STATe
•
*RST Condition: CALibration:STATe:DC ON
Example Disabling DC Calibration Corrections
CAL:STAT:DC OFF Disables DC corrections.
CALibration
Chapter 8 Command Reference 305