User`s manual

Example Starting a Frequency Sweep
SWE:START 1E3;STOP 10E3 Sets sweep frequency limits.
SWE:POIN 10 Sets 1 kHz steps.
ARM:SOUR IMM Sets output to start immediately.
ARM:SWE:SOUR HOLD Sets manual sweep arm.
INIT Initiates trigger system.
ARM:SWE Starts sweep.
:SWEep:LINK
ARM:SWEep:LINK <link> selects the internal event that starts a frequency sweep
or list when
ARM:SWEep:SOURce is set to LINK. The only defined internal event
to start a sweep or list is “
ARM[:STARt | :SEQuence[1]]:LAYer2”.
There is no need to send this command since there is only one defined internal
event. The command is included for SCPI compatibility purposes only.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
<
link>
string “ARM[:STARt | :SEQuence1]:LAYer2” none
Comments • Executable when Initiated: Yes
• Coupling Group: None
• Related Commands: ARM:SWEep:SOURce
•
*RST Condition: ARM:SWEep:LINK “ARM[:STARt | :SEQuence[1]]:LAYer2”
Example Linking the Sweep Arm
ARM:SWE:SOUR LINK Links sweep arm to start arm.
ARM:SWE:LINK “ARM”
ARM
296 Command Reference Chapter 8