User`s manual

The steps of this program are:
1. Set the sweep mode
[SOURce:]FREQuency[1]:MODE SWEep
2. Set the start frequency
[SOURce:]FREQuency[1]:STARt <start_freq>
3. Set the stop frequency
[SOURce:]FREQuency[1]:STOP <stop_freq>
4. Set the number of sweeps
[SOURce:]SWEep:COUNt INFinity
5. Set the number of points in a sweep
[SOURce:]SWEep:POINts <number>
6. Set the sweep time
[SOURce:]SWEep:TIME <number>
7. Select the source to start a sweep
ARM:SWEep:SOURce LINK
8. Set the number of waveform repetitions
ARM[:STARt]:LAYer[1]:COUNt <number>
9. Set the number of waveform arm starts
ARM[:STARt]:LAYer2:COUNt <number>
10. Select the source to start waveform output
ARM[:STARt]:LAYer2:SOURce <source>
11. Set the output function
[SOURce:]FUNCtion[:SHAPe] <shape>
12. Set the signal amplitude
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <amplitude>
13. Place the AFG in the wait-for-arm state
INITiate[:IMMediate]
14. Trigger the AFG to start a sweep
use the source selected above in Step 10
Chapter 5 Arming and Triggering 187