User`s guide

Agilent E6432A Microwave Synthesizer User’s Guide 4-245
featureBits
Variable Type ViUInt16
This parameter specifies the features used while setting a frequency
and power level. One or more features can be selected. To select a single
feature, specify its feature bit value. To select multiple features, add the
desired feature bit values together.
alcOffset
Variable Type ViInt16[]
This parameter specifies an ALC integrator zero offset value (a 16 bit
value) that is applied to the ALC Integrator Zero DAC at each
corresponding list point. This allows minimal shift in the power from
the value sent as power when the ALC loop is opened.
Valid range: 0 - 4095
The ALC integrator zero offset value is ignored unless the featureBits
parameter sets Bit 3=1.
numberOfPoints
Variable Type ViUInt32
featureBits Description
--- With all featureBits set to 0, set a frequency and power level,
but do not generate a Sync Out trigger, do not adjust ALC
Offset, and do not use long banking.
Bit 0=1 Reserved
Bit 1=1 Do not blank RF output unless the step attenuator is
changed.
Bit 2=1 Set switch/blanking time to long switch/blanking; normal
switch/blanking time is 150 us and long switch/blanking time
is 350 us.
Bit 3=1 Use the ALC integrator zero offset value that is passed in
from the alcOffset parameter in place of the ALC integrator
zero offset value from the frequency table.
Bits 4-7 Reserved
Bit 8=1 The synthesizer will produce a Sync Out trigger at the end of
the Settling Time
Bits 9-15 Reserved