User`s guide

Agilent E6432A Microwave Synthesizer User’s Guide 1-11
Installation
Installation of the E6432A Microwave Synthesizer
Installation of the E6432A Microwave
Synthesizer
Prior to Installation of the E6432A
Prior to installation of the E6432A microwave synthesizer, items listed
as A through G must be completed as called out in “Hardware and
Software Requirements Prior to Installation” on page 1-3.
1. Set the E6432A microwave synthesizer’s logical address.
The unit is factory set to be Auto Configured at address 255 (FF).
Agilent VEE requires a fixed address. Factory suggestion is address
210 (D2).
2. Turn power OFF to the C-size VXI mainframe and install the
E6432A microwave synthesizer.
3. Turn power ON to the C-size VXI mainframe and run one of the
following:
4. Install the E6432A VXIplug&play driver software from the supplied
CD.
If the CD does not auto install, run Setup.exe from the Windows NT
Start taskbar.
Run… One Slot 0 Module Being Used
I/O Config Agilent E8491B IEEE-1394 PC Link to VXI
- Using a PCI to IEEE-1394 Interface
Resman NI VXI-MXI-2 - Using a PCI-MXI-2 Interface
SURM Agilent E623x VXI Embedded PC Controller or
equivalent