User`s guide

Agilent E6432A Microwave Synthesizer User’s Guide 3-129

Soft Front Panel Help

External Modulator Gain Calibration

Reset External Detector Calibration to Factory

Default

Reset External Detector Calibration to Factory Default, available from

the Pull Down Calibration Menu, is used to restore factory preset

values for the external leveling loop configuration. These factory preset

values are changed when a detector linearization calibration or

modulator-gain frequency table calibration is performed.

This selection should be used if a calibrated external leveling loop

configuration has been changed, or if difficulties occur while performing

calibrations on the external leveling loop configuration.

NOTE To obtain calibration values for an external leveling loop configuration

after performing this selection, the External Detector Linearization and

External Modulator Gain Calibration must be performed again.