User`s guide

Agilent E6432A Microwave Synthesizer User’s Guide 1-7
Installation
(Option 1) Install the Agilent Technologies I/O Library (which contains
Agilent Technologies VISA 1.1)
(Option 1) Install the Agilent Technologies I/O
Library (which contains Agilent Technologies
VISA 1.1)
Install the Agilent Technologies I/O library from the CD that came with
the Slot 0 module being used. If you have problems or questions
regarding the installation process, refer to the manufacturer’s
documentation that came with the Slot 0 module being used. Additional
information related to this product can be obtained using the Internet
at: http://www.agilent.com
• If using Slot 0 Module (Agilent E8491B IEEE-1394 PC Link to VXI) -
Using a PCI to IEEE-1394 Interface, the following must be
performed during the installation process of the I/O library:
a. Check the box labeled, “Install Agilent E8491 VXI Components.”
(This installs code for the PCI to IEEE-1394 interface card.)
b. Check the box labeled, “Configure interfaces automatically”.
(If this box is not checked, you can manually configure the
PCI to IEEE-1394 interface card using the I/O Config utility
located in the I/O Libraries program folder.
The I/O Config utility is used by the I/O Libraries to configure
instrument I/O interfaces. An interface must be configured with
the I/O Config utility before it can be used with the I/O Libraries.)
c. Reboot the Windows NT computer and VXI mainframe so that
changes take effect.
d. Perform the steps describing “Installation of the E6432A
Microwave Synthesizer” on page 1-11.