User`s guide

3-64 Agilent E6432A Microwave Synthesizer User’s Guide
Soft Front Panel Help
List Dialog Box
Related Topics
Soft Front Panel Help
List Dialog Box Controls
Trigger Input
Configuration Dialog Box
HPE6432_RunList
Working with Lists (A Programmer’s Model)
Sync In (0, 1, 2, 3) - List Playing Control
Sync In #, available from the List Dialog Box, specifies the action that a
Sync In trigger has on the current list.
Sync In triggers can come from the Sync In connector on the hardware
front panel or one of the eight-shared VXI backplane TTL triggers
(TTLTRG0-TTLTRG7). Refer to Sync Input, available from the
Configuration Dialog Box, to control which signal will be used as the
Sync In trigger.
Sync In 0 – Auto Sync (Ignore)
This setting causes Sync In to be ignored so that Sync In does not affect
the operation of list mode.
Sync In 1 – Wait for Sync In to Start List
This setting starts at the beginning of the list after receiving a Sync In
trigger; if in Repeat Mode, a new Sync In trigger is required at the end
of the list to restart the list. Advancement through the list is dependent
on the Trigger Input Mode.
Sync In 2 – Restart Running List on Sync In
This setting restarts the list at any point in the list while it is running.
The list will restart automatically after reaching the end of the list and
does not require a new Sync In trigger.