Service manual

28 Installing Mainframe Options Chapter 2
Install Rack Slide Stationary Sections (Figure 2-10)
Note For non-cabinets, you must add End Brackets (1494-0061) to
the Rack Slide Kit (1494-0413). See the instructions for the
1494-0061 kit to install the rack slides.
The Rack Slides occupy the center EIA unit of the three EIA units required
for the E8408A mainframe.
1 Slide four 10-32 Self-Retained Nuts on the selected holes in the right
hand vertical column of the cabinet. See Figure 2-10 for hole
locations.
2 Attach the RH Rack Slide Stationary Section to the right hand vertical
column of the cabinet. Use two 10-32 x 0.5" flat head screws at the
front of the rack slide, and two 10-32 x 0.375" pan head screws at
the rear of the rack slide.
3 Repeat steps for the LH Rack Slide Stationary Section.
Figure 2-10. Installing Rack Slide Stationary Sections
C
L
Pan head
Screws
Right Hand
Rack Slide
Stationary
Section
Right Hand
Vertical
Columns
Self Retained
Nuts
Flathead
Screws