Service manual

20 Installing Mainframe Options Chapter 2
Rack Mounting Using Rack Slide Kit
This section contains instructions to mount the E8408A mainframe
in a standard EIA cabinet
using the Rack Mount/Cable Route Adapter Kit
(E8397A) and the Rack Slide Kit (p/n 1494-0413). The rack slide kit allows
you to extend the mainframe from the cabinet for easier access to installed
instruments.
Parts List Table 2-2 shows the parts for the Standard Rack Mount/Cable Routing Kit
and for the Rack Slide Kit.
Installation
Procedure
There are three main steps to rack mount the E8408A mainframe using the
Rack Mount/Cable Route Adapter Kit (E8397A) and the Rack Slide Kit
(1494-0413):
• Configure the Mainframe
• Set up Rack Cabinet
• Install the Mainframe
Table 2-2. Rack Mount Kit and Rack Slide Kit Parts Lists
Quantity Description Part Number
Rack Mount/Cable Route Adapter Kit (E8397A)
1 Rack Mount Adapter (right) E8408-61200
1 Rack Mount Adapter (left) E8408-61201
2 Handle (for Rack Mount Adapters) RAF p/n 8344-1032-A34
4 10-32 X 0.375" Flat Head Screw (Handle Screws) 2680-0100
12 M3 X 0.5 Pan Head Screw (Adapter-to Mainframe Screws) 0515-0372
4 Adapter Dress Screw 0570-1577
4 Self-Retained Nut (for Rack Mount Adapters) 0590-0804
1 Front Panel Label Set (Rack-Mount Orientation) E8408-84305
Rack Slide Kit (1494-0413)*
1 pair Rack Slides General Devices p/n
CC1502-99-0016
12 10-32 X .375" Pan Head Screw 0515-0904
4 10-32 X .50" Flat Head Screw 0515-0956
8 10-32 Self-Retained Nut 0590-0804
* For non-Agilent cabinets, must add 1494-0061 End Brackets