User`s manual

Terminal Module Options
Besides the standard screw-type terminal module, the Agilent E1418A can
be ordered with the following two options. One option (A3E) provides
crimp-and-insert connectors and terminal housing. The other option (A3H)
provides a ribbon cable connector and terminal housing.
Option A3E Agilent E1418A Option A3E can be ordered if a crimp-and-insert terminal
module is desired. This allows you to crimp connectors onto wires which
are then inserted directly into the Agilent E1418A faceplate connector.
Refer to the pin-out diagram on page 30 to make the connections. The
crimp-and-insert connector is shown in Figure 1-10.
Note The pin numbering on the crimp-and-insert connector may not agree with the
pin numbering on the Agilent E1418’s faceplate connector. Use the pin
numbering on the faceplate connector to wire the crimp-and-insert connector.
Figure 1-10. Option A3E Crimp-and-Insert Connector
Chapter 1 Module Setup and Installation 27