User manual

86 Relay Multiplexer Command Reference Chapter 3
STATus:OPERation:CONDition?
STATus:OPERation:CONDition? returns the state of the Condition
Register in the Operation Status Group. The state represents conditions
which are part of the instrument’s operation. The multiplexer driver does
not set bit 8 in this register (see STATus:OPERation[:EVENt]?).
STATus:OPERation:ENABle
STATus:OPERation:ENABle <number> sets an enable mask to allow
events recorded in the Event Register to send a summary bit to the
Status Byte Register (bit 7). For multiplexer modules, when bit 8 in the
Operation Status Register is set to 1 and that bit is enabled by the
STATus:OPERation:ENABle command, bit 7 in the Status Register is set
to 1.
Parameters
Comments Setting Bit 7 of the Status Register: STATus:OPERation:ENABle 256 sets
bit 7 of the Status Register to 1 after bit 8 of the Operation Status
Register is set to 1.
Related Commands: [ROUTe:]SCAN
Example Enabling the Status Register
STAT:OPER:ENAB 256
!Enables bit 8 of the Operation Status
Register to be reported to bit 7 (OPR)

in the Status Register
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns which bits in the Event Register
(Operation Status Group) are unmasked.
Name Type Range of Values Default
<number> numeric 1 through 65,535 N/A