User manual

26 Getting Started Chapter 1
Wiring Terminal
Modules
Figures 1-11 and 1-12 show suggested steps to connect field wiring (user
inputs) to a terminal module.
Continued on next page
Figure 1-11. Steps to Wire Terminal Modules
Install Connectors (Crimp-and-Insert)4
Tighten screw.
Insert wire into terminal.
Screw-Type
Make Connections
Remove Clear Cover
3
1
VW1 Flammability
Use wire
Rating
Size 16-26
AWG
0.2"
5mm
Tab
and Release
B. Press Tab Forward
A. Release Screws
Route Wiring5
secure wires
Tighten wraps to
Use wire
Size 22-26
wire exit panels
Remove 1 of the 3
Remove and Retain Wiring Panel
Crimp-and-Insert
2
2.5mm
0.1"
AWG