User manual

Table 1-3. Option A3E Terminal Module Accessories
Crimp-and-
Insert
Co
ntacts
The crimp-and-insert connector is normally supp
lied with Option A3E. Contact Agilent if
additional connectors are needed. Order 91484B.
24 Getting Started Chapter 1
Figure 1-9. Option A3E Crimp-and-Insert Connector
Accessory Description Picture Specifications
Single-
Conductor
and Contact
A crimp-and-insert contact is crimped
onto one end of a wire. The other end
is not terminated. Order 91510A.
Length: 2 meters
Wire Gauge: 24 AWG
Quantity: 50 each
Insulation Rating: 105
o
C max
Voltage: 300 V
Shielded-
Twisted-Pair
and Contacts
A crimp-and-insert contact is crimped
onto each conductor at one end of a
shielded-twisted-pair cable. The
other end is not terminated. Order
91511A.
Length: 2 meters
Wire Gauge: 24 AWG
Outside Diameter: 0.1 inches
Quantity: 25 each
Insulation Rating: 250
o
C max
Voltage: 600 V
Jumper Wire
and Contacts
A crimp-and-insert contact is crimped
onto each end of a single conductor
jumper wire. This jumper is typically
used to tie two pins together in a
single crimp-and-insert connector.
Order 91512A.
Length: 10 cm
Wire Gauge: 24 AWG
Quantity: 10 each
Insulation Rating: 105
o
C max
Voltage: 300 V
These contacts may be crimped onto
a conductor and then inserted into a
crimp-and-insert connector. The
crimp tool kit is required to crimp the
contacts onto a conductor and
remove the contact from the
connector. Order 91515A.
Wire Gauge Range: 20-26 AWG
Quantity: 250 each
Plating: Gold Plated Contact
Maximum Current: 2A at 70
o
C
Crimp-and-
Insert Tools
The hand crimp tool (part number 91518A) is used for crimping contacts onto a conductor. 
The pin extractor tool (part number 91519A) is required for removing contacts from the
crimp-and-insert connector. These products are not included with Option A3E or with the
terminal option accessories listed earlier.
Extra
Crimp-and-
Insert
Connectors