User manual

Disassembly Use the following procedures to disassemble the ME1460A relay module
(see Figure 4-1):
To remove the top shield:
• Remove the six T10 Torx screws as shown.
• Lift the top shield off of the module.
To remove the bottom shield:
• Slide A1 in the direction shown until the retaining pins
on the shield align with the larger holes on A1.
• Lift A1 off of the bottom shield.
To remove the front panel and front panel handles:
• Remove the two T8 Torx screws as shown.
Figure 4-1. ME1460A Relay Module Disassembly
Agilent E1460A Service Manual Service 53