User manual

Index 119
P
programming the multiplexer, 29
R
READ registers, description, 102
reconfiguring relay switch, 19
register addressing, 99
register offset, 101
register-based programming, 99, 107
registers
Device Type, 104
ID, 104
Relay Control, 104
Status⁄Control, 103
Relay Control registers, 104
relay multiplexer specifications, 97
relay switch, reconfiguring, 19
reset conditions, 36
restricted rights statement, 7
[ROUTe:] subsystem, 72
[ROUTe:]CLOSe, 72
[ROUTe:]CLOSe?, 74
[ROUTe:]FUNCtion, 75
[ROUTe:]FUNCtion?, 76
[ROUTe:]OPEN, 77
[ROUTe:]OPEN?, 79
[ROUTe:]SCAN, 79
[ROUTe:]SCAN:MODE, 80
[ROUTe:]SCAN:MODE?, 82
[ROUTe:]SCAN:PORT, 82
[ROUTe:]SCAN:PORT?, 83
S
safety symbols, 8
saving and recalling states, 56
scan complete bit, 51
scanning channels, 43
scanning multimeter, 11
SCPI commands
abbreviated commands, 60
command reference, 61
command separator, 60
format, 59
implied commands, 60
linking commands, 61
parameter types, 61
quick reference, 96
SCPI commands
format, 30
variable commands syntax, 60
SCPI drivers
checking, 29
downloading, 30
setting interrupt priority, 17
setting logical address switch, 16
setting status register switch, 17
specifications, 97
standard terminal module, description, 23
status register switch, setting, 17
STATus subsystem, 84
STATus:OPERation:CONDition?, 86
STATus:OPERation:ENABle, 86
STATus:OPERation:ENABle?, 86
STATus:OPERation[:EVENt]?, 87
STATus:PRESet, 87
Status⁄Control register, 103
switchbox, 11
switching channels, 37
synchronizing the multiplexer, 58
SYSTem subsystem, 88
SYSTem:CDEScription?, 88
SYSTem:CPON, 89
SYSTem:CTYPe?, 89
SYSTem:ERRor?, 90
T
terminal module Option A3E, description, 23
terminal modules
attaching, 28
configuring, 23
three-wire mode operation, 14
TRIGger[:IMMediate], 91
TRIGger:SLOPe, 92
TRIGger:SLOPe?, 92
TRIGger:SOURce, 92
TRIGger:SOURce?, 94
two-wire mode operation, 14
U
user inputs, connecting, 25
V
VXI Installation Consultant (VIC), 30