User manual

Index 117
Index
E1460A Relay Multiplexer User’s Manual
A
A16 address space
inside command module, 101
outside command module, 100
ABORt subsystem, 62
addressing the multiplexer, 30
analog bus
connecting, 22
using, 52
ARM subsystem, 63
ARM:COUNt, 63
ARM:COUNt?, 64
attaching terminal modules, 28
B
base address, registers, 99
C
cautions, 15
channel addresses, 32
channel relay switches, 12
checking SCPI drivers, 29
command reference, 61
command types, 59
common commands
*CLS, 95
*ESE, 95
*ESE?, 95
*ESR?, 95
*IDN?, 95
*OPC, 95
*OPC?, 95
*RCL, 95
*RST, 95
*SAV, 95
*SRE, 95
*SRE?, 95
*STB?, 95
*TRG, 95
*TST?, 95
*WAI, 95
command reference, 95
format, 59
C (continued)
configuring terminal modules, 23
configuring the multiplexer, 15
configuring wire jumpers, 18
connecting the analog bus, 22
connecting user inputs, 25
control relays, 13
D
declaration of conformity, 9
detecting error conditions, 56
Device Type register, 104
documentation history, 8
downloading SCPI drivers, 30
E
error conditions, detecting, 56
error messages, 115
examples
Advancing Scan Using TRIGger, 91
Cable Testing, 53
Closing Multiplexer Channels, 74
Configuring Multiplexer Mode, 76
Connecting the Analog Bus, 52
Enabling "Trig Out" Port, 70
Enabling a Single Scan, 67
Enabling Continuous Scanning, 66
Enabling ECL Trigger Bus Line 0, 69
Enabling the Status Register, 86
Enabling TTL Trigger Bus Line 7, 71
Error Checking Using Interrupts, 57
Error Checking Using Polling, 56
Four-Wire Ohms Measurements, 81
Initial Operation, 34
Multiplexer Module Channel Lists, 33
Opening Multiplexer Channels, 78
Opening/Closing Multiplexer Channels, 108
Querying "Trig Out" Port Enable State, 70
Querying Channel Closure, 74
Querying Channel Open State, 79
Querying Continuous Scanning State, 66
Querying ECL Trigger Bus Enable State, 69
Querying Number of Scans, 64