Service manual

Removing
Binding Posts
Use the following steps to remove the E1411 front panel binding posts
(MP3, MP4, MP5, and MP6) (see Figure 8-3).
1. Unsolder wire
2. Remove the 3/8-32 nut and spring washer
3. Remove the binding post
4. Reverse the order to reinstall the binding posts
Soldering
Printed Circuit
Boards
The etched circuit boards in the multimeter have plated-through holes that
allow a solder path to both sides of the insulating material. Soldering can be
done from either side of the board with equally good results. When
soldering to any circuit board, keep in mind the following guidelines:
CAUTION
Do not use a sharp metal object such as an awl or twist drill, since
sharp objects may damage the plated-through conductor.
Figure 8-3. Removing Binding Posts
Agilent E1411A/E1411B Service Manual Service 61