Service manual

NOTE
When reinstalling the top shield, verify that the slots are aligned with the
tabs, then set the top shield into place.
Removing
Front Panel
Use the following steps to remove the front panel and bottom shield from
the printed circuit assembly (PCA). See Figure 8-2 for component locations.
1. Remove Torx T8 screw from front panel
2. Remove two Torx T8 screws from PCA
3. Remove cable assembly from clip
4. Slide PCA off bottom shield
5. Reverse steps 1 through 4 to replace front panel and
bottom shield
Figure 8-2. Removing Front Panel
60 Service Agilent E1411A/E1411B Service Manual