Service manual

230 END
Test 4-4: Resistance Test (4-Wire Ohms)
This test verifies the 4-wire resistance accuracy of the 2kΩ, 100kΩ, and
1MΩ ranges.
NOTE
The DC Voltage performance test must be performed prior to the Resistance
Test to check the A/D accuracy on all ranges. If the DC Voltage test has not
been performed, resistance must be checked on all ranges at 0 and at 50%
of full scale.
Equipment Setup 1. Connect the equipment as shown in Figure 4-4
Figure 4-4. Resistance Test Setup
Agilent E1411A/E1411B Service Manual Verification Tests 27