Specifications

FET Multiplexers When the FET strain gage multiplexers are shipped from the factory, the
card ID switches are set to the "OPEN" (0) position (Figure 1-1). The
terminal module is identified when the module is plugged onto the
component assembly and when the mainframe is turned on.
Note When the terminal card is not attached, the system identifies the multiplexer
as an HP E1351A 16-channel FET multiplexer when the card ID switches
are in the OPEN (0) position.
Figure 1-1. Checking the Card ID Jumper/Switch
Chapter 1 Getting Started with the Strain Gage Multiplexers 15
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com