Service manual

Chapter 3
Replaceable Parts
Introduction This chapter contains information to order replaceable parts for the Agilent
E1351A, E1352A, E1353A, E1357A, and E1358A FET Multiplexers. Table
3-1 lists replaceable parts for major assemblies of the FET Multiplexers.
Table 3-2 lists selected mechanical parts for the Component assembly.
Table 3-3 lists parts for the terminal case. Table 3-4 shows reference
designators for the parts listed in Tables 3-1 through 3-3. Table 3-5 shows
the manufacturer code list for these parts.
To order a part listed in Table 3-1 through through 3-3, specify the Agilent
Technologies part number and the quantity required. Send the order to your
nearest Agilent Technologies Sales and Support Office.
Replaceable
Parts Lists
Table 3-1 lists the part numbers of the major assemblies of the FET
Multiplexers. Table 3-2 lists mechanical replaceable parts for the
Component Assembly (common to all FET Multiplexers). Table 3-3 lists
replaceable parts for the Terminal Case Assembly (Common to all FET
Multiplexers)
Figure 3-1 shows the Component Assembly and Figure 3-2 shows the
Terminal Case Assembly.
A CLIP package, including component level replaceable parts lists, is
available for the FET Multiplexers (order Agilent part number
E1351-90033).
Exchange
Assembly
The component assembly may be replaced on an exchange basis. Exchange
assemblies are available only on a trade-in basis. Defective assemblies must
be returned for credit. Order assemblies for spare parts stock by the new
assembly part number given in Table 3-1. Terminal blocks and case
assemblies are not available for exchange. The component assembly
exchange part number is: E1351-69201
Replaceable Parts 3-1