User`s manual

Appendix C
Agilent E1346A Multiplexer Error Messages
Table C-1 lists the error messages associated with the multiplexer modules
programmed by SCPI. See the appropriate mainframe manual for a
complete list of error messages.
Table C-1. 48-Channel Multiplexer Error Messages
No. Title Potential Cause(s)
-211 Trigger ignored Trigger received when scan not enabled. Trigger received after scan complete.
Trigger too fast.
-213 Init Ignored Attempting to execute an INIT command when a scan is already in progress.
-224 Illegal parameter value Attempting to execute a command with a parameter not applicable to the command.
1500 External trigger source
already allocated
Assigning an external trigger source to a switchbox when the trigger source has
already been assigned to another switchbox.
2000 Invalid card number Addressing a module (card) in a switchbox that is not part of the switchbox.
2001 Invalid channel number Attempting to address a channel of a module in a switchbox that is not supported
by the module (e.g., channel 99 of a multiplexer module).
2006 Command not
supported
on this card
Sending a command to a module (card) in a switchbox that is unsupported by the
module.
2008 Scan list not initialized Executing a scan without the INIT command.
2009 Too many channels in
channel list
Attempting to address more channels than available in the switchbox.
2012 Invalid Channel Range Invalid channel(s) specified in SCAN <channel_list>command. Attempting to begin
scanning when no valid channel list is defined.
2600 Function not supported
on this card
Sending a command to a module (card) in a switchbox that is not supported by the
module or switchbox.
2601 Channel list required Sending a command requiring a channel list without the channel list.
Appendix C Agilent E1346A Multiplexer Error Messages 71