User`s manual

The A16 base address used in register-based programming depends on
whether the A16 address space is located inside the E1300(01)
Mainframe/E1406 Command Module or elsewhere (e.g. embedded
computer). Figures B-1, B-2, and Table B-1 enable you to determine the
base address for the following computer configurations:
• E1300/E1301 Instrument BASIC (IBASIC)
• External Computer over GPIB to E1300/E1301 Mainframe or E1406
Command Module
• V/382 Embedded Controller (C-Size system)
Computer
Configurations
This section contains performance and functional information on the
computer configurations that can be used with register-based programming.
Throughput Speed Throughput speed is based on the amount of command parsing and whether
the registers are accessed from the VXI backplane or from the GPIB. The
computer configurations which allow faster throughput relative to each
other are summarized on page B-3.
Figure B-2. Multiplexer Registers within E1300/E1406 A16 Address Space.
64 Agilent E1346A Multiplexer Registers Appendix B