User`s manual

Command Quick Reference
The following tables summarize SCPI and IEEE 488.2 Common (*)
commands for the 48-Channel Single Ended Relay Multiplexer Module
used in a switchbox.
SCPI Commands Quick Reference
Command Description
ABORt Abort a scan in progress.
ARM :COUNt <number>
:COUNt? [MIN |MAX]
Multiple scans per INIT command.
Query number of scans.
INITiate :CONTinuous ON |OFF
[:IMMediate]
Enables/disables continuous scanning.
Starts a scanning cycle.
DISPlay :MONitor[:STATe] <boolean>
:MONitor:CARD<number>|AUTO
Selects monitor mode.
Selects module to be monitored.
OUTPut [:STATe] ON |OFF Enables/disable s "Trig Out" pulse.
[ROUTe:] CLOSe <channel _list>
CLOSe? <channel _list>
OPEN <channel_list>
OPEN? <channel _list>
SCAN <channel_list>
SCAN:MODE NONE |VOLT |RES
Close channel(s).
Query channel(s) closed.
Open channel(s).
Query channel(s) opened.
Define channels for scanning.
Selects appropriate Channel Switches for Volts or 2-wire ohms
measurements.
STATus :OPERation[:EVENt]?
:OPERation:ENABle
Returns status of Operation Status Register.
Enables the Operation Status Register to set a bit in theStatus Register.
SYSTem :ERRor?
:CDEScriprion? <number>
:CTYPe? <number>
:CPON <number>|ALL
Returns error number/message in a switchbox Error Queue.
Returns description of module in a switchbox.
Returns the module type.
Sets specified module to its power-on state.
TRIGger [:IMMediate]
:SOURce BUS
:SOURce EXTernal
:SOURce HOLD
:SOURce IMMediate
:SOURce?
Causes a trigger to occur.
Trigger source is *TRG.
Trigger source is "Event In" BNC.
Hold off triggering.
Continuous (internal) triggers.
Query scan trigger source.
IEEE 488.2 Common Commands Quick Reference
Command Title Description
*RST Reset Opens all channels, and invalidates current channel list for scanning. Sets ARM:COUN 1,
TRIG:SOUR IMM, and INIT:CONT OFF.
*TRG Bus Trigger When scan is enabled and trigger source is TRIG:SOUR BUS, use the *TRG command to
trigger the switchbox to advance the scan.
TST? Self-Test Always returns 0
60 Agilent E1346A Multiplexer Command Reference Chapter 5