User`s manual

Example Selecting the 2-Wire Ohms Mode
TRIG:SOUR EXT Selects external trigger source
SCAN:MODE RES Selects the 2-wire ohms scanning
mode
SCAN (@100:147) Sets channel list
INIT Starts scanning cycle
SCAN:MODE? [ROUTe:]SCAN:MODE? returns the current state of the scan mode. The
command returns NONE, VOLT, or RES if the scan mode is in the NONE,
VOLT, or RES mode, respectively.
Example Query Scan Mode
Since this example selects the RES (ohms) mode, the query command
returns RES.
SCAN:MODE RES Selects the 2-wire ohms scanning
mode
SCAN:MODE? Query the scanning mode
Chapter 5 Agilent E1346A Multiplexer Command Reference 53