User`s manual

20 OUTPUT 70914;"OUTP ON" Enables "Trig Out" port
30 OUTPUT 70914;"TRIG:SOUR BUS" Sets switchbox to receive Bus
triggers
40 OUTPUT 70914;"SCAN (@100:147)" Selects the channel list
50 OUTPUT 70914;"INIT" Starts scanning cycle
60 FOR I=1 TO 48 Start count loop
70 ENTER 722;A Enter reading into variable A
80 PRINT A Print reading in variable A
90 TRIGGER 70914 Trigger the switchbox to advance
the channel list
100 NEXT I Increment count
110 END
SCAN:MODE [ROUTe:]SCAN:MODE NONE |VOLT |RES sets the multiplexer channels
defined by the [ROUTe:]SCAN <channel_list> command for None, Volts,
or 2-wire Ohms measurements.
Parameters
Parameter Name Parameter Type Range of Values
NONE |VOLT |RES discrete NONE |VOLT |RES
Comments
• Order of Command Execution: The [ROUTe:]SCAN:MODE
command must be executed before the
[ROUTe:]SCAN <channel_list>command.
• NONE Mode Description: Channel list is setup for a voltage
measurement. This is the default setting of the multiplexer module
and it is therefore not required to send this command for a voltage
measurement.
• VOLT Mode Description: See the NONE Mode description above.
• RES Mode Description: Channel list is setup for 2-wire ohms
measurements. Automatically closes the DT Tree Switch (channel
93) for ohms measurements.
• *RST Condition: [ROUTe:]SCAN:MODE NONE.
52 Agilent E1346A Multiplexer Command Reference Chapter 5