User`s manual

Index 91
R (continued)
Register-Based Programming
, 77–83
base address, 78–79
computer configurations, 79
DIAG:PEEK?, 79–80
DIAG:POKE, 79–80
embedded computers, 80
external computers, 80
IBASIC, 80
register number, 80
register offset, 80
throughput speed, 79–80
VXI:READ?, 79–80
VXI:WRITE, 79–80
Registers
addressing
, 77–79
base address, 78–79
channel, 80
channel register, 81–83
control register, 81–83
definitions, 83
device type register, 81, 83
ID register, 81, 83
number, 80
offset, 80
operation status register, 46, 63–64
reading, 81
status register, 46, 63, 81–83
tree switch register, 81–83
Relay Life, 73–75
Relay Replacement Strategy, 75
Resetting the Module, 82
Resistance Measurement, 34
Resistors
location of
, 13
purpose of, 12
[ROUTe:] Subsystem, 58–62
[ROUTe:]CLOSe, 31, 33, 58
[ROUTe:]CLOSe?, 31, 33, 59
[ROUTe:]OPEN, 31, 33, 35, 59
[ROUTe:]OPEN?, 33, 60
[ROUTe:]SCAN, 31, 38, 60–61
[ROUTe:]SCAN:MODE, 31, 38, 61
[ROUTe:]SCAN:MODE?, 62
[ROUTe:]SCAN:PORT, 31, 38, 62
*RST, 71–72
RT Tree Switch, 12–13
closing, 39
S
Safety Warnings, 19
*SAV, 71
Scan Complete Bit, 46
Scanning
channels
, 60
commands, 41–42
continuous cycles, 38, 55
cycle, 51, 56
continuous, 38, 55
multiple, 38
query, 52
query state, 56
range of channels, 36
requirements of a switchbox, 38
trigger sources, 41, 69–70
using
bus triggers
, 70
event in port, 45
external triggers, 69
trig out port, 45
with external instruments, 41, 44, 60–61
Scanning Voltmeter
card numbers
, 14–15
configuration, 14, 24
logical address, 24
selecting channels, 14
Schematic, simplified, 13
SCPI Commands, 47–49, 72
abbreviated, 48
ABORt, 50
ARM subsystem, 51–52
DISPlay subsystem, 53–54
format used, 16, 47
implied, 16, 48
INITiate subsystem, 55–56
linking, 49
optional, 16, 48
parameters, 49
OUTPut subsystem, 57
parameters, 49
programming with, 14
quick reference, 72
reference, 49–70, 72
[ROUTe:] subsystem, 58–62
scanning, 42
STATus subsystem, 63–64