User`s manual

Index 89
E (continued)
Examples (continued)
scanning 4-wire ohms measurements
, 38
scanning using event in port, 45
scanning using trig out port, 45
scanning with external devices, 44, 60–61
External
computer programming
, 80
devices, scanning with, 60–61
trigger port, 44–45
triggers, scanning with, 69
F
Field Wiring, connecting, 20
Five Volt Excitation for Strain Gages, 27
G
Getting Started, 11–18
GPIB
interface select code
, 17, 41, 46
primary address, 17, 41, 46
secondary address, 17, 41, 46
service request (SRQ), 46
Guidelines, wiring, 20
I
IBASIC Programming, 80
ID Register, 83
reading, 81
*IDN, 71
IEEE 488.2 Commands
Common (*) Commands
, 47
Implied Commands, 16, 48
Initial Operation, 17
INITiate Subsystem, 55–56
INITiate:CONTinuous, 31, 38, 55
INITiate:CONTinuous?, 56
INITiate[:IMMediate], 31, 56
Insulation Resistance, 73–74
Interrupt
generating
, 26
level, 73–74
lines, 26
priority, selecting, 26
scan complete, 46
J
Jumper
card ID
, 23
interrupt priority, 26
JM1 and JM2, 27
terminal module, 12
L
Linking Commands, 49
Logical Address, 14–15, 23
changing, 23
factory setting, 23
scanning voltmeter, 24
switch, setting, 23
switchbox, 25
verifying settings, 25
Low Pass Filter Configuration, 27–28
M
Measure
2-wire ohms
, 34
by scanning, 38
4-wire ohms, 35
by scanning, 38
channels, 11
multiplexer channels, 11
resistance, 34
temperature
using multimeters
, 40
using thermistors, 40
using thermocouples, 39–40
thermistor, 12
resistance, 39
thermocouple voltage, 39
voltage, 34
by scanning, 36
with multimeters, 35
Modules, terminal, 11, 20–21
Multimeter
external trigger port
, 44–45
measuring with, 35, 39–40
primary address, 41
voltmeter complete port, 45